Chemical Injection Fitting - For 3/8" Tubing

The Blue-White C-395N-6A fitting is installed at the injection point of the tubing for soap and other chemical discharge lines. This device prevents backflow from a treated line and helps distribute solutions evenly. This polypropylene fitting is installed directly into either 1/4" or 1/2" female pipe threads (NPT). The barb fitting is designed for 3/8" tubing.

• 6 PSI internal spring (crack pressure)
• Polypropylene body material
• For 3/8" (.37") tubing
• 1/4" and 1/2" Male NPT pipe installation
• The nose section is designed to inject the chemical away from the wall of your pipe

INSTALLATION OPTIONS:

Directly into a pipe:

• Drill the correct size hole and then tap the hole for 1/4" or 1/2" NPT.
• Use PTFE" thread sealing tape on the pipe threads of the injection fitting.
• This illustration shows the injection fitting installed directly into pipe using the 1/4" threads.

Directly into a tee fitting:

• The solution must inject directly into the flow stream.
  
• Use PTFE thread sealing tape on the pipe threads of the injection fitting.
  
• This illustration shows the injection fitting installed in a tee fitting using the 1/2" threads.

WARNING: This product can expose you to chemicals including Lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm (For more information go to www.p65warnings.ca.gov).