Series 3350 Nylon T-Line Strainer - 1/2" FNPT

This Hypro 3350-0043 Line Strainer is ideal for suction or pressure applications up to 150 PSI. This line strainer removes solids and particulates that may cause inconsistencies in flow and damage to equipment. The cap and bowl are made with nylon 6 material and the screen is made from stainless steel. This line strainer has an 80 on 20 mesh screen, 1/2" FNPT ports, and a Buna-N gasket.

• 1/2" FNPT connection ports
• 80-20 stainless steel mesh
• 150 PSI maximum pressure rating at 70° F
• 125 PSI maximum pressure rating at 140° F
• Head and bowl made with nylon 6
• Buna-N gasket

Installation:

• In most circumstances, install the line strainer on the inlet side of the pump. If using a centrifugal pump, as trainer can be installed on either the inlet or discharge side, depending on the strainer flow capacity, strainer pressure rating, and other installation factors. The arrow molded in the strainer cap indicates flow of liquid.

Cleaning:

• Clean the strainer without removing it from the line. Simply unscrew the bowl from the cap and take out the screen. Next, flush the sediment from the screen. Reassemble the strainer by first fitting the screen to the flange in the bowl. Turn the bowl hand tight, which provides a sufficient seal against the cap. NOTE: Not recommended for fatigue-loading applications such as water softeners.

WARNING: This product can expose you to chemicals including Lead, which is known to the State of California to cause cancer and birth defects or other reproductive harm (For more information go to www.p65warnings.ca.gov).